Blade mCP X V2 RTF Manual de instrucciones descargar pdf (Pagina 7)

Transmitter and Receiver Binding

If you purchased an RTF model, the transmitter is bound to the model at the factory.

To bind or re-bind your mCP X to your chosen transmitter, please follow the directions below:

BindingistheprocessofprogrammingthereceiverofthecontrolunittorecognizetheGUID(GloballyUnique

Identier)codeofasinglespecictransmitter.Youneedto‘bind’yourchosenSpektrum

™

or JR

DSM

technology equipped aircraft transmitter to the receiver for proper operation.

NOTICE:UsetheNon-ComputerRadiobindinginstructionsifyouareusingaDX4eorDX5etransmitter

with the mCP X BNF.



Binding Procedure for Non-Computer Radio (DX4e, DX5e)

1. Disconnect the ﬂight battery from the helicopter.

2.Poweroffthetransmitterandmoveallswitchestothe0position.

3.Connecttheightbatterytothehelicopter.The3-in-1ControlunitLEDashesafter5seconds.

4.Pushinonthetrainerswitchorbuttonwhilepoweringonthetransmitter.

5.MovetheruddercontrolsticktofullleftafterthetransmitterLEDlightsashtwice.

6.Releasethetrainerswitch/button.Continuetoholdtheruddercontrolsticktofullleftuntiltheblue

LEDonthe3-in-1controlunitissolid.

7.Releasetheruddercontrolstick.

8.Pushinonthetrainerswitch/button.TheblueLEDonthe3-in-1controlunitashestoconrmthe

helicopter is in non-computer mode.

9. Disconnect the ﬂight battery and power the transmitter off.



Binding Procedure for Computer Radios:

1. Disconnect the ﬂight battery from the helicopter.

2.Poweroffthetransmitterandmoveallswitchestothe0position.

3.Connecttheightbatterytothehelicopter.The3-in-1ControlunitLEDashesafter5seconds.

4.Pushinonthebindswitch/buttonwhilepoweringonthetransmitter.

5.After2–3seconds,releasethebindswitch/button.

6.Movetheruddercontrolsticktofullright.Continuetoholdtheruddercontrolsticktofullrightuntil

theblueLEDonthe3-in-1controlunitissolid.

7.Releasetheruddercontrolstick.

8.Disconnecttheightbatteryandpowerthetransmitteroff.

The throttle will not arm if the transmitter’s throttle control is not put at the lowest position and the stunt mode

switch is not in the 0 position.

If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other

instructions.Ifneeded,contacttheappropriateHorizonProductSupportofce.

ForalistofcompatibleDSMtransmitters,pleasevisitwww.bindny.com.

If the swashplate moves up and down when the trainer switch is moved, the helicopter is in computer

transmitter mode; repeat binding procedure.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Sin comentarios

Blade mCP X V2 RTF Manual de instrucciones Pagina 7