Blade Glimpse FPV RTF Manual de instrucciones descargar pdf (Pagina 8)

1. Lower the throttle and throttle trim to the lowest settings.

2. Power on the transmitter.

3. Install the battery by sliding it into the battery mounting slot.

4. Connect the battery cable to the 4-in-1 control unit as shown.

5. Place the quadcopter upright on a ﬂ at surface and leave the aircraft still until the LED on the 4-in-1 control unit is

solid blue (not blinking).

CAUTION: Always disconnect the Li-Po battery from the aircraft when not ﬂ ying to avoid over-discharging

the battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,

resulting in loss of performance and potential ﬁ re when the batteries are charged.

Installing the Flight Battery

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Sin comentarios

Blade Glimpse FPV RTF Manual de instrucciones Pagina 8