Blade mCX2 RTF Manual de instrucciones descargar pdf (Pagina 11)

Withthestickpulledback,theright-handservoshouldpushtheswashplateupward.

Movetheright-handstickleftandrighttocheckaileronrollcontrol.Whenthestickispushedtothe

left, the left-hand servo should pull the swashplate downward.

Withthestickpushedright,theleft-handservoshouldpushtheswashplateupward.

If at any time during the test the controls respond in the opposite direction, it may be necessary to

reverse/change the direction of operation of the ﬂight controls. Follow these steps to change the direc-

tion the various ﬂight controls:

• Be certain that the battery is disconnected from the battery lead of the 5-in-1 control unit and the

transmitter is turned off.

• Pushdownontheappropriatedigitaltrimbuttononthetransmitterforthecontrolyouwouldlike

tochangethedirectionof.Forexample:

Top elevator trim button—elevator channel normal

Bottom elevator trim button—elevator channel reversed

Left aileron trim button—aileron channel normal

Right aileron trim button—aileron channel reversed

• Continue to hold the appropriate trim button while turning the transmitter on.

• Holdthedigitaltrimbuttondownforapproximatelyveseconds,untilaseriesofbeeps/tonesare

heard conﬁrming the selection.

• Connect the battery to the 5-in-1 and complete the ﬂight control test, conﬁrming that all controls

are operating in the correct directions.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 91 92

Sin comentarios

Blade mCX2 RTF Manual de instrucciones Pagina 11