Blade mCX2 RTF Manual de instrucciones descargar pdf (Pagina 8)

MLP4DSM and ParkZone Vapor/Ember 2 Transmitters

AfterverifyingtheLEDisashingonthereceiver/5-in-1,PUSHdirectlydownontheleft-handstick

whileswitchingthetransmitteron(youwillfeela‘click’whenyoupushinontheendofthestick).

Afterapproximately5–10secondsthereceiver/5-in-1shouldbeboundtothetransmitterandyou

should now have full control and function.

LP5DSM

IfyoudecidetouseanE-iteLP5DSMtransmitter,pleasepositionyourchannelreversaldipswitches

as follows.

1. Plug the ﬂight battery into the 5-in-1 unit. After 5 seconds the LED on the 5-in-1 unit will

begin ﬂashing.

2.Movethesticksandswitchesonthetransmittertothedesiredfailsafepositions(lowthrottleand

neutralcontrolpositions).

3. Turn the transmitter on. The red LED located under the door on the bottom left front of the trans-

mitterwillblinkrapidly.

DX5e and DX6i

1.Movethesticksandswitchesonthetransmittertothedesiredfailsafepositions(lowthrottleand

neutralcontrolpositions).

2. For the DX5e: Pull and hold the Trainer Switch on the transmitter while turning the transmitter on.

Release the trainer switch once the LEDs on the front of the transmitter ﬂash.

3. For the DX6i: Pull and hold the Trainer Switch on the transmitter while turning the transmitter on.

Release the trainer switch once “BIND” Flashes on the LCD screen of the transmitter.

4.Afterapproximately5–10secondsthereceiver/5-in-1shouldbeboundtothetransmitterandyou

should have full control and function.

DX7, DX7se, X9303, or 12X:

1.Movethesticksandswitchesonthetransmittertothedesiredfailsafepositions(lowthrottleand

neutralcontrolpositions)

2.Pressthebindbuttononthebackofthetransmitterwhileturningthetransmitteron.Thebind

buttononthebackofthetransmitterwillash.Releasethebuttonafter2–3seconds.

3.Afterapproximately5-10secondsthereceiver/5-in-1shouldbeboundtothetransmitterandyou

should now have full control and function.

Additional Binding Information

Prior to each ﬂight, power on your transmitter and wait about ﬁve seconds before you plug the ﬂight

battery into the receiver. This allows time for the transmitter to scan and secure two open frequencies.

Ifyouplugtheightbatteryintooquicklyandmissthelink,thereceivermayinadvertentlyenterbind

mode. If this occurs leave the transmitter on, then disconnect and reconnect the ﬂight battery.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 91 92

Sin comentarios

Blade mCX2 RTF Manual de instrucciones Pagina 8