Blade mCX2 RTF Manual de instrucciones descargar pdf (Pagina 15)

Dual Rates

TheMLP4DSMtransmitterincludedwithyourBlademCX2RTFisequippedwithadualratefeature.

This feature allows the pilot the toggle between the high and low control rates available for the aileron,

elevator and rudder channels. To toggle between the high and low rates, push in on the right-hand

stickonthetransmitter(whilethetransmitterispoweredon).

Thetransmittercomessetinhigh-ratemode.Youcantellyouareinthehigh-ratemodewhentheLED

onthetransmitterglowssolidred.Inhigh-ratemodethecontrolsareallowedtoreachtheirmaximum

values,typicallypreferredbyexperiencedpilotsformaximumcontrolauthority.

Pushtheright-handstickinwhileinhigh-ratemodetoenterlow-ratemode.Youcantellyouarein

thelow-ratemodewhentheLEDonthetransmitterblinkscontinuously.Thelow-ratemodeistypically

preferredby(andbestfor)rst-time,low-timeandotherpilotsmostinterestedinreducedcontrolthat

allows for smoother and more easily controlled hovering and ﬂying.

Note: The throttle curve in the low rate mode is also different than it is in the high rate mode. This

makeslow-rate-modethrottlesmootherandeasiertocontrol.

Choosing a Flying Area

When ready for your ﬁrst ﬂight, select a relatively open indoor area free of people and obstructions.

WhileitispossibleforexperiencedpilotstoytheBlademCX2inrelativelysmallindoorareaswith

greatsuccess,westronglyrecommendanareawithatleast10-feetby10-feetofoorspaceandno

lessthan8-footceilingswhenmakingyourrstfewights.

Once you properly trim your helicopter and become familiar with its handling and capabilities, you will

be able to ﬂy in other smaller, less open areas.

Note:TheBlademCX2isdesignedandintendedtobeownINDOORSONLY.

Flying the Blade mCX2

Note: In addition to reviewing the ﬂight maneuvers outlined below, we recommend you watch Videos

located on the product page for the Blade mCX2 on www.horizonhobby.com to see many of these

maneuvers and adjustments performed by the helicopter and pilot.

• Slowlyraisethethrottlestick,increasingthespeedofthemainrotorbladesuntilthemodel

begins to lift off. Do not raise the throttle stick too quickly as the model could climb too fast

causing you to lose control or make contact with objects above.

• Liftthemodeloffthegroundjustafewinchesandconcentrateonbalancingthethrottlestick

positionsothatthemodelholdsasteadyhoveraltitude.Insomecasesitmaybebesttomake

a few short “hops” to an altitude of just a few inches until you become familiar with the control

inputs and trim settings required to maintain a steady hover and altitude.

As you will ﬁnd, the Blade mCX2 requires minor throttle adjustments to maintain its altitude in

hover.Remembertokeepthesethrottleadjustmentsasminimalaspossibleaslargeadjustments

could result in a loss of control and/or a possible crash.

Aileron

Left

Right

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 91 92

Sin comentarios

Blade mCX2 RTF Manual de instrucciones Pagina 15