Blade mCX2 RTF Manual de instrucciones descargar pdf (Pagina 6)

Battery Charging

Follow these steps to charge the Li-Po battery with the included charger:

1. Remove the cover on the bottom of the charger and install four of the included AA batteries, not-

ing proper polarity. Replace the cover after the AA batteries are installed.

2. Slide the battery into the slot on the charger. The endcap

of the battery has been speciﬁcally designed to allow the

batterytobeslidintothesloteasilyoneway(usuallywith

thelabelonthebatteryfacingoutward)topreventreverse

polarityconnection.However,checkforproperalignment

andpolaritybeforeproceedingtothenextstep.

3.Gentlypressthebatteryanditsconnectorintothecharge

jack/connectorlocatedatthebottomoftheslotonthe

charger.

4. Once the connection is successful, the LED light on the

charger turns solid red, indicating

charging has begun.

5.Afullydischargedbattery(notover-discharged)takesapproximately30–40minutestocharge.

Asthebatterynearsfullcharge,theLEDlightwillblink.WhenthebatteryisfullychargedtheLED

lightblinksapproximatelyevery20secondsorgoesoutentirely.

The Li-Po battery included with your Blade mCX2 will arrive partially charged. For this reason the initial

chargemayonlytake15–20minutes.

YoucanexpecttochargetheLi-Poightbatteryapproximately15–20timesbeforeitwillbeneces-

sary to replace the AA batteries in the charger. An optional 6V power supply is also available separate-

ly(EFLC1005).ThispowersupplywillallowyoutochargeathomewithouttheneedforAAbatteries.

Installing the Transmitter Batteries (RTF ONLY)

InstallfouroftheincludedAAbatteriesinthetransmitter.Checkforproperoperationofthetransmitter

byswitchingthepowerswitchon(totheleft).TheLEDlightatthetopofthetransmittershouldbegin

to glow solid red while the transmitter beeps.

1 2 3 4 5 6 7 8 9 10 11 ... 91 92

Sin comentarios

Blade mCX2 RTF Manual de instrucciones Pagina 6