Blade mCX2 RTF Manual de instrucciones descargar pdf (Pagina 5)

Battery Warnings and Guidelines

Theincludedbatterycharger(EFLC1000)hasbeendesignedtosafelychargetheincluded

Li-Po battery.

CAUTION:Allinstructionsandwarningsmustbefollowedexactly.MishandlingofLi-Po

batteries can result in a ﬁre, personal injury, and/or property damage.

•Byhandling,chargingorusingtheincludedLi-Pobattery,youassumeallrisksassociatedwith

lithium batteries.

•Ifatanytimethebatterybeginstoballoonorswell,discontinueuseimmediately.Ifchargingor

discharging, discontinue and disconnect. Continuing to use, charge or discharge a battery that is

ballooning or swelling can result in ﬁre.

•Alwaysstorethebatteryatroomtemperatureinadryareaforbestresults.

•Alwaystransportortemporarilystorethebatteryinatemperaturerangeof40–120ºF(4.44–48.88º

C).Donotstorebatteryoraircraftinacarordirectsunlight.Ifstoredinahotcar,thebatterycanbe

damaged or even catch ﬁre.

•Alwayschargebatteriesawayfromammablematerials.

•Alwaysinspectthebatterybeforechargingandneverchargedamagedbatteries.

•Alwaysdisconnectthebatteryaftercharging,andletthechargercoolbetweencharges.

•Alwaysconstantlymonitorthetemperatureofthebatterypackwhilecharging.

•ONLYUSEACHARGERSPECIFICALLYDESIGNEDTOCHARGELI-POBATTERIES.Failuretocharge

the battery with a compatible charger may cause ﬁre resulting in personal injury and/or property

damage.

•NeverdischargeLi-Pocellstobelow3Vunderload.

•Nevercoverwarninglabelswithhookandloopstrips.

•Neverleavechargingbatteriesunattended.

•Neverchargebatteriesoutsiderecommendedlevels.

•Neverattempttodismantleoralterthecharger.

•Neverallowminorstochargebatterypacks.

•Neverchargebatteriesinextremelyhotorcoldplaces(recommendedbetween40–120°For

4.44–48.88°C)orplaceindirectsunlight.

Low Voltage Cuto (LVC)

When a Li-Po battery is discharged below 3V, the battery may be damaged and may no longer accept

a charge. The mCX2’s 5-in-1 control unit protects the ﬂight battery from over-discharge using Low

VoltageCutoff(LVC).Beforethebatterychargedecreasestoomuch,LVCremovespowersupplyfrom

themotor.PowertothemotordecreasesandtheLEDonthe5-in-1controlunitblinks,showingsome

battery power is reserved for ﬂight control and safe landing.

When the motor power decreases, please land the aircraft immediately and recharge the ﬂight battery.

DisconnectandremovetheLi-Pobatteryfromtheaircraftafterusetopreventtrickledischarge.Before

storage,chargetheLi-Pobatterytofullcapacity.Duringstoragemakesurethebatterychargedoes

not go below 3V.

NOTICE: Repeated ﬂying to LVC will damage the battery.

1 2 3 4 5 6 7 8 9 10 ... 91 92

Sin comentarios

Blade mCX2 RTF Manual de instrucciones Pagina 5